ISO-MME Data

ISO-MME data is supported (versions 1.6 and 2.0 are supported). All the channels (curves) defined in the index file will automatically be extracted and labelled (tagged) with their ISO channel codes. ISO-MME data will typically be test data obtained from a physical crash test, but the tool will work with ISO-MME data that has been generated from simulation results, for example, by using the Ansys LS-DYNA to ISO-MME workflow tool.

Instructions for importing ISO-MME data in SimVT can be found in this Ansys LS-DYNA with ISO-MME Example.

Click on the button on the Correlation Setup window

IMPORTANT: ISO-MME data is assumed to be in SI units. Some test houses provide angular results in degrees rather than in radians. Please check your ISO-MME test data before importing it to ensure that angles are in radians. This applies to rotations, angular velocities and angular accelerations.

Previous | Next