Options

OR

The graph options controls can be found under the Options section of the Plotting Controls Window or in the Plot button dropdown of the Correlation Table Window. You can specify any combination of the following options:

Corridor options

• Plot corridor graph - controls if the corridor graph is plotted (Note: one of the graphs must be plotted).
• Show corridors - controls if the corridors are plotted on the corridor graph (if not, only the curves are plotted, not the corridors). Note that this option does not apply when multiple corridors graphs are combined (corridors cannot be shown in this case) and only when one simulation and test result is shown on a single plot.
• Plot cross correlation graph - controls if the cross correlation graph is plotted (Note: one of the graphs must be plotted).

Diagnostic options

• Dynamic corridor visualisation - controls if coloured zones to check corridor performance over time is shown.
  There are three coloured zone:
  1. High correlation zone: If data point on sim curve is within both inner and outer corridor curve then it falls into this zone. Zone is highlighted with pale green colour.
  2. Moderate correlation zone: If data point on sim curve is within both outer corridor curve but outside inner corridor curve it falls into this zone. Zone is highlighted with pale yellow colour.
  3. Low correlation zone: If data point on sim curve is outside both inner and outer corridor curve then it falls into this zone. Zone is highlighted with pale red colour.
• Show time of poorest correlation - controls if the time of poorest correlation is highlighted. Time of poorest correlation is the time at which sim curve and test curves are farthest among all the points (see example below)
• Show start of divergence - controls if the start time of divergence between sim and test curve leading to poorest correlation is highlighted. (see example below)

NOTE: If the whole sim curve is within inner corridor curve we don't show Time of poorest correlation and Start of divergence.

Legend options

• Show legend - controls if a legend is displayed on the graph.
• Add scores to legend - controls if the rating scores are written onto the legend of the graph.
• Add method to legend - controls if the rating method is written onto the legend of the graph.

Graph options

• Add time bounds - controls if vertical lines (dashed red) representing the evaluation interval are displayed on the graph.
• Add scores to graph title - controls if the rating score is added to the title of the graph (Note: this only applies to corridor graphs).

Multiple Model options

• Combine corridor graphs - controls if corridor graphs that share the same channel are combined in a single graph.

Layout

• Change layout – controls the graph layout of the T/HIS session.

Below is an example of a plot with Dynamic corridors visualisation ticked, Show corridors option is ticked (left) and when it is unticked (right).

Below is an example of Time of poorest correlation highlighted on the sim curve with green cross and Start of divergence highlighted with cyan triangle.

Below is an example of a combination of plots with Combine corridor graphs unticked (left) and ticked (right).