THIS 22.1

Command Line Mode

Command line mode

In command line mode editing of curves is done in a similar fashion using the following commands.

Moving around the curve:

F Forward Move forward 16 lines

B Back Move back 16 lines

T Top Move to the top of the curve

E End Move to the end of the curve

N Number

Move to given line number

Modifying the curve:

Cn Change Change line n

In Insert Insert points before line n

An Append Append points after line n

D n1 n2 Delete Delete lines n1 to n2

L Label Change the line label

R Reset

Reset the curve back to the original curve

Saving and Plotting the curve:

W Write Write the curve

S Save As write

PE Plot Edited Plot the edited curve

PA Plot All Plot the edited and original curve

PL Plot Plot the current T/HIS curves

Q Quit Quit the editor
In command line mode the EDIT menu is reached by typing /ED