THIS 22.1
APPENDIX G - The ERROR Calculation
APPENDIX G - The ERROR Calculation
|
The ERROR function outputs a number of values to indicate the degree of correlation between 2 curves. The function requires two input curves
|
|
|
|
Once 2 curves have been selected the a check is carries out to see if the two curves contain the same number of points and if the range of x-axis values the same for the two curves. If any inconsistencies are found then a warning message is generated.
|
|
The following values are then calculated
|
| Maximum difference and time of variation | |
| Maximum difference as a %age of the reference value at the same time | |
| Maximum difference as a %age of the peak reference value | |
| Average difference | |
| Average difference as a %age of the peak reference value |
|
|
| T/HIS Regression coefficient. | |
|
|
| This is a value between 0 and 1 where 1 means 100% correlation | |