The following programs retrieve information from an OTF file.
|
Added mass at end of analysis
|
Prints the mass added to the analysis by mass-scaling at the end of the
analysis. This will also look at otf files generated from restarts (otf01,
otf02 etc)
|
|
Added mass at start of analysis
|
Prints the mass added to the analysis by mass-scaling at the start of
the analysis.
|
|
Percentage final added mass
|
Prints the percentage mass added to the analysis by mass-scaling at the
end of the analysis. This will also look at otf files generated from restarts
(otf01, otf02 etc)
|
|
Percentage initial added mass
|
Prints the percentage mass added to the analysis by mass-scaling at the
start of the analysis.
|
|
Total mass in analysis
|
Prints the mass of the model at the start of the analysis
|
|
Mass-scaled timestep (DT2MS) echo in OTF file
|
Prints the
DT2MS
value from the
*CONTROL_TIMESTEP
card echoed to the OTF file.
|
|
Smallest initial timestep
|
Prints the element with the smallest timestep from the 100 smallest
timesteps. The line has the form:
<element_type> <element_number> timestep
= <timestep>
|
|
Elapsed time for analysis
|
Prints the total elapsed time for the analysis.
|
|
Start time for analysis
|
Prints the date and time that the analysis finished.
|
|
Problem cycle for analysis
|
Prints the cycle in the analysis that the problem terminated.
|
|
Problem time for analysis
|
Prints the time in the analysis that the problem terminated.
|
|
Start time for analysis
|
Prints the date and time that the analysis started (same as Analysis date).
|
|
Terminition time(ENDTIM) echo in OTF file
|
Prints the termination time from the
*CONTROL_TERMINATION
card echoed to the OTF file. This will also look at otf files generated
from restarts (otf01, otf02 etc).
|
|
Analysis date
|
Prints the date and time that the analysis started
|
|
Analysis precision
|
Prints the precision (single/double) Ansys LS-DYNA used for the analysis
|
|
Analysis title
|
Prints the title of the analysis echoed to the OTF file.
|
|
CPU time for analysis
|
Prints the total CPU time used for the analysis. This will also look at
otf files generated from restarts (otf01, otf02 etc)
|
|
Check on the quality of the run
|
Looks to see if the analysis terminated normally, if the initial and final
added masses, the total energy fluctuation and hourglass energy are below
(user definable) limits. Either prints OK or NOT OK.
|
|
Hostname analysis run on
|
Prints the hostname of the machine the analysis was run on.
|
|
Ansys LS-Dyna version and revision
|
Prints the version and revision of Ansys LS-DYNA used to run the analysis
|
|
Normal or Error termination message
|
Prints
Normal
or
Error
termination
message from Ansys LS-DYNA.
|
|
Number of CPUs used for analysis
|
Prints the number of CPUs used for the analysis
|
|
OS analysis run on
|
Prints the operating system level of the machine the analysis was run
on.
|
|
Platform analysis run on
|
Prints the platform of the machine the analysis was run on.
|