PRIMER 22.1
Writing the Model Using Select Files
Writing the Model Using Select Files
To save the model once it has been built, in the main menu right click on Model and select write in the pop-up.
In the Write to file window input the name you wish to save the master file under in the input box:
|
Select appropriate options in the Pre-Output check window:
|
If you select mode and any include files have been renumbered during the build process PRIMER will prompt you to change to mode, where the renumbered includes will be preselected, putting up the following panel.
|
|
will then take you to the keyout selected panel.
Note - PRIMER stores a marker that the component has been renumbered, this is not a rigorous check for modified includes. To achieve that you need to use the compare to disk function described above. |
