PRIMER 22.1

Steps for Finger Positioning

Select the 2 nodes for the palm, with node 1 being the node near the thumb and node 2 being near the last finger.

step1_actual step1_menu

Select the 2 nodes for the thumb, with node 1 being the node at the top of the thumb and node 2 being at the bottom.

step2 step2_menu

Select a rigid part within the wrist, this is used for connections/joints

step3 step3_menu

Select the solids for the thumb part as shown below.

step4 step4_menu

Select the solids for the finger 1 part as shown below.

step5 step5_menu

Select the solids for the finger 2 part as shown below.

step6 step6_menu

Select the solids for the finger 3 part as shown below.

step7 step7_menu

Select the solids for the finger 4 part as shown below.

step8 step8_menu

Click apply to create the finger assemblies containing the solids which have been selected.

Click on the cancel button to start over again.