PRIMER 22.1
MESHING
MESHING
PRIMER has some simple meshing facilities. The options available under the Meshing tool are:
| Mesh | Simple meshing facilities such as extrude , offset , ruled surfaces , plates etc |
| Split | Split shells |
| Create hole | Create a hole in an existing mesh |
| Remove hole | Remove a hole from an existing mesh |
| Remesh area | Remesh an area of existing mesh |
| Cobweb mesh | Create a cobweb mesh on an existing mesh |
| Morph | Morph a mesh |
| Tet mesh | Create a tetrahedron mesh inside a closed volume of shells |
| Geometry | Mesh geometry surfaces |