Fitting Options
Fitting Options
In PRIMER V13 a new Fitting Options panel was added. This combines existing settings that were previously a bit hard to get at during belt fitting with some new capabilities.
It is mapped automatically when 2:Fit mode is entered, and it is recommended that it is moved to one side of the screen, or possibly onto the desktop,so that it does not obscure the dummy during belt path creating and subsequent fitting.
If it is dismissed it can be mapped again using the button in the path editor, or the button on the main panel.
This section goes through every capability on the panel, some of which has already been covered in the sections above. These will be repeated in brief with references to the earlier sections.