Finish Setup

Finish Setup

Finally, if you selected a combined dummy/HBM positioning and seat squash analysis with the 'end position' method you will need to define a vector to depenetrate the dummy/HBM out of the seat so that PRIMER can calculate the start and intermediate dummy positions.

You can then create the model(s) to run in Ansys LS-DYNA. This will output a dynain file containing the final coordinates which can then be imported back into the original model.

Once the model(s) have been created you will need to write them out from PRIMER and then run them in Ansys LS-DYNA. This should produce a DYNAIN file for each model containing the coordinates and initial stress information from the analysis.

They can be imported back into the original model using PRIMER following the steps described here.