Airbag Folding Summary

Airbag Folding Summary

The following process should be followed when folding an existing airbag mesh:

Read in a model containing airbag geometry (and possibly Origami definitions), and enter the PRIMER airbag module by using the AIRBAGS buttons. Define an ORIGAMI or select an existing one using DEFINE_ORIGAMI . Set the local coordinate system if your airbag is not in the global xy plane using LOCAL_SYSTEM Set the plotting modes that you require using the Fold Plotting Mode , Airbag Plotting Mode and Symbol Plotting Mode radio buttons. Set any options for the airbag folder using FOLDER OPTIONS Define or modify folds using SET_FOLD using subset folding , sets and layers as appropriate. If required position the folded bag using POSITION FOLDED BAG Exit airbag folder by pressing APPLY . Note that other methods of exiting from this model will lose current fold definitions. Save the model to disk.