(1) SEARCH DISTANCE Mode

(1) SEARCH DISTANCE Mode

This is made active by setting a Distance value (in this example 100) in the interpolate box. This value remains current until changed, setting this value to 0 turns interpolation off again.

The Interpolate button is shown in red when it is active.

Once a Distance value has been set the coordinates of unselected nodes within a radius < Distance > of any explicitly selected nodes will have their coordinates updated as follows:

	Where:	C	= Coordinate of this node
			= Coordinate change due to Translation / Rotation / Scale
		d	= Distance from this node to nearest explicitly selected node
		D	= The specified Distance value
		Order	= The specified Order value

The Order value defaults to 1.0, giving a linear interpolation, but any positive value > 0.001 is permissible, and a sketch of the factor vs. distance is shown in the box. (In the figure above 0.5 has been used.)