D3PLOT 22.1

METAL FORMING

METAL FORMING

The METAL FORMING panel contains a number of special options and plotting modes for use with metal forming analysis. The figure (below) shows the basic METAL FORMING REFERENCE control panel.

This panel consist of three sections.

  1. The top part of the panel accesses a number of special plotting modes, see METAL FORMING plotting options .
  2. The middle part of the panel allows entities to be selected for some of the plotting options in the top part of the panel and the states to use for the Strain Path calculation (all by default), see METAL FORMING Entity and State Selection .
  3. The bottom part of the panel allows a number of variables to be entered which are used by some of the plotting options in the top part of the panel, see METAL FORMING Data Values


Previous | Next