D3PLOT 22.1
GSA Data
GSA Data
This is available from D3PLOT 13.0 and compatible with GSA 7.2.
This figure (right) shows the menu for writing an ASCII file of results in .gwa format that can be read into GSA for the corresponding analysis case.
Where multiple states are selected, each state will be output in order as a new analysis case with an incremented case number.
If a component is not available in the D3Plot model the option is greyed out. SPCs have not been fully implemented so their selection is always greyed out.
| TASK NUMBER | Input the task used in the corresponding GSA analysis case. |
| FIRST CASE NUMBER | Input the first case number used in the corresponding GSA analysis case. |
| LOAD DESCRIPTION | Input the load description used in the corresponding GSA analysis case. |
| SELECT STATES | Select the states you want to output GSA data for. |
Limitations:
1. D3Plot shell and beam data is only output as averaged centre values.
2. The forces and moments element data is in the local topological axis (rather than a user defined or global axis).