D3PLOT 22.1
Defining Output Parameters in Ansys LS-DYNA
Defining output parameters in Ansys LS-DYNA
The following Ansys LS-DYNA control cards control output of this file:
| *DATABASE_BINARY_INTFOR | Allows you to set an output frequency for this file different to that used for the .PTF file, which is the default. (Note that you must request this file when submitting the job in order for it to be written.) |
It is strongly recommended that you DO NOT use an output frequency for this file that is different to that used for the .PTF file. If you do D3PLOT can have problems trying to synchronise contact surface data with other results.
This file contains the topology and results for all segmented contact surfaces in the model. You have no control over its internal structure.
Generic contents of the .CTF file
|
||||||||||||||||||||||||||||||